This customer more than cut his electric bill in half by installing a domestic hot water system and a 2100W PV system.

The small array in the middle powers his pool pump. Note the stagger in the placement of the main array. A detailed shade analysis revealed an 18% increase in power harvest from the main array during several of the winter months.

Nice residential system is comprised of Evergreen 195W modules, UniRac mounting, and SunnyBoy inverter.

This garage/workshop was built for this PV array!  It is beautiful and is sized to reduce the customer's electric bill by 85% annually.  Sharp 216W modules x 36.  Perfect installation

Large commercial PV system.  This customer will virtually eliminate FPL bill and will capture huge rebates for a system that is almost free.  140 PV modules mounted on a metal roof with no roof penetrations!

Who says PV needs to go on a house?  This system on the west coast of Florida is beautiful!

This is a PVP inverter, 5200W max AC output.  The D/C disconnect is on the left, A/C disconnect (opt.) on the right.

This 3500W system in Satellite Beach, FL consists of 20 Sharp 175 mono-crystalline PV modules.

This residential PV system uses Evergreen 190W modules for a total of 5320W DC.

Here is a beautiful installation on a metal roof. When the electriciy co-op officials inspected this system, they were awed: "We finally found a [solar contractor] who knows what they are doing!" 5070W DC, BP 195W panels

This is how we install on a tile roof. Perfect. Under the tile is a mounting plate with two 3-1/2" stainless steel lag bolts turned directly into the truss. That's over 1100lbs of pull-out strength in this single mount!

These solar modules are beautiful!  They are mounted on a metal roof.

SMA makes some of the best inverters - they are clean, efficient, and reliable.  This SB4000US inverter mounted in a garage completes a nice money-saving system for the customer. 

This large residential PV system employs two SB5000US inverters.  A/C disconnect is shown below.

Large commercial system.  This is what a combiner box should look like: organized, labeled, high quality components, easy for troubleshooting if necessary.

This system employs SolarWorld 230W modules. These are arguably the highest quality solar panels available; they are perfect. We design every system specifically for each customer. We do not use kits or pre-assembled packages.